GE 6 X-EC
Flex Giraffe® eccentric sander for walls and ceilings: its long arm lets you sand at height without scaffolding. Supplied with 150 and 220 grit abrasives and a carry bag.
Pack of 25 Flex sanding sheets for sanding surfaces before painting or finishing. Eight grits, from P40 to P220, to strip back, level or refine depending on the substrate.
Estimated delivery: 3 à 5 jours
The Flex Xtreme Plus abrasive paper is a 225 mm perforated disc designed for sanding filled surfaces, drywall and plasterboard. It removes filler burrs and irregularities, and leaves a smooth, even finish with less effort. It is sold in packs of 25, in 8 grits from P40 to P220, to cover the whole job, from rough sanding to finishing.
Start by choosing the grit according to the stage. P40 is used for rough sanding of filled and plastered surfaces, and P60 for intermediate sanding. The finer grits (P80 to P220) are then used to refine the surface before painting. Before sanding, check that the filler is dry and that any major excess thickness has been removed with a spatula.
Work with a sander suited to the 225 mm diameter (long-reach wall sander, or "giraffe" type), connected to a vacuum cleaner. The disc's multiple holes are useless without extraction. Keep the pad flat and move it in regular passes, without pressing too hard, so as not to dig into the filler.
Replace the disc as soon as it clogs or loses its bite. A clogged disc heats up, makes sanding uneven and damages the surface.
| Usage | Dégrossissage (P40), ponçage intermédiaire (P60), finition |
| Marque | Flex – Xtreme Plus |
| Supports | Surfaces enduites, cloisons sèches, plaques de plâtre |
| Diamètre | 225 mm |
| Perforation | Multi-trous pour aspiration |
| Conditionnement | 25 pièces |
| Grains disponibles | P40, P60, P80, P100, P120, P150, P180, P220 |
The classic mistake is to start too coarse and then try to "make up for it" afterwards. On properly applied filler, P40 is only useful for removing real excess thickness. In most cases, start with P60 or P80 and finish with a finer grit. Each pass with the next grit up should erase the scratches left by the previous one. Avoid skipping several grits at once.
To check the result before painting, use raking light (a work lamp placed close to the wall): hollows, burrs and remaining scratches show up immediately. Correct them at this stage, because paint, especially in a satin finish, will accentuate them.
Le P40 est prévu pour le dégrossissage des surfaces enduites et plâtrées. Le P60 convient au ponçage intermédiaire. Pour la finition, passez ensuite à des grains plus fins, du P80 jusqu'au P220 selon le rendu souhaité.
Le diamètre est de 225 mm pour tous les grains de la gamme Xtreme Plus. Vérifiez que votre ponceuse accepte ce format avant de commander.
Chaque lot contient 25 disques du même grain. Il faut donc choisir un grain par lot, parmi P40, P60, P80, P100, P120, P150, P180 et P220.
Ils permettent l'aspiration de la poussière pendant le ponçage. Raccordez votre ponceuse à un aspirateur pour en profiter. Le chantier reste plus propre et la surface est mieux dégagée.